Assessmeent continues:30/06/2009

Tuesday morning our assessors came to continue with our assessment and everything went well as planned.We managed to complete 3 modules bringing them to a total of 7 modules.

Assessment:29/06/2009

Monday morning Mr P. Nolte accompanied by Mr R .S Hagemann arrived in our classroom ready to assess us on 3 modules including a new one known as Construct Basic Electronic Circuit.Assessment went absolutely great except the Basic Electronic module which needs proper attention for re-assessment.

Preparation for assessment:25/06/2009

It was Thursday where our facilitator informed us that the date for assessment has been postponed to the 29 of June 2009.Ufortunately it was not easy for me because I could not make time to study.

Preparations for assessment:22/06/2009

On the 21 of J une 2009 I was restless studying for the coming assessment with our new assessor Mr P Nolte coming along with Mr R.S Hagemann.Unfortunaetely they could not come due to other prioprities,but what is good about it is that I tried to study some of the modules though it was not that simple.

Cable joint:19/06/2009

Friday morning around 10:30 am we cut off the cable supplying the pump motor because it was burnt out.We did managed to replace the damage one and join it using MX 2 but not connecting it to the motor due to the drying of the resin.

Presentations :18/06/2009

Thursday morning we did some touch ups in completion of activity 3 and preparations for our presentation.At around 09:30 our facilitator came marking the activity and giving us an equal opportunity to share everything we did research on.Further more we planned how our schedule is going to be next week Tuesday because during Mondays and Fridays we do practicals around Sondela(electrical maintenance).

Activities:17/06/2009

We did activity 3 as planned with our facilitator.We also agreed to do research using internet on the new given task concerning presentations on Thursday.

Electrical maintenance:12/06/2009

We replaced fuorescent tubes (75watts) and their ballast to make sure that they glow.During the maintenance process we also managed to create a new stand to mount an additional fluorescent light controlled by a single lever.

Assignment :11/06/2009

Wednesday morning I completed the given assignment based on the fundamentals.Later on before 12am i submitted it to Heidi our facilitator while doing research about our next activity.

Wiring

On the 10th of June 2009 I wired a sub DB and installed a fluorescent light together with an ordinary bio net fitting.Further more we continued to connect the double plugs.later on we connected the supply to our sub DB supplied from a transformer over a distance of approximately 1km.Since it was a long distance,we did some test (we plugged a grinder) to ensure that there was no drop in voltage and we were very fortunate because there was a slide volt drop (From 228v to 224v).Our mission was accomplished due to our great ideas.